Roof brace kit

£80.00

Prices are Incl. Tax Excl. Shipping

£80.00

If your chimney comes out above your roof more than five feet you are required to use a roof brace kit. A kit is required every additional five feet.

To install a roof brace kit you will need the following tools:

Level, silicone, drill 1/4"drill bit, and 1" wood screws which are not provided in the hardware package.

  • To begin wrap the support band around the chimney at about 5' up the chimney.
  • You received 4 poles two will slide into the other two. For this step go ahead and slide the poles together. place the poles about 60 degrees apart from each other or make a large triangle shape see photo 1 below.
  • Make sure the chimney is level and set the poles where you want them, then place the roof brackets on the roof under the braces. Put some silicone under the brackets and then screw 4 1" wood screws about half way in each bracket. Put some silicone around the screws and screw them all the way down.
  • attach the poles to the brackets and tighten everything down.
  • The last step is to drill a 1/4" hole through the pole and put a nut and bolt through the hole and tighten down.
  • The last step is to either put more silicone around the storm collar or at least check to make sure you didn't break the silicone seal during the installation of the roof brace kit.

Additional Information

Name Roof brace kit
Reference number 03091511KDW
Inside pipe AISI 316L (1.4404)
Outside pipe AISI 304 (1.4301)
Overlap 6 cm
Thickness inside pipe 0.4
Thickness outside pipe 0.4
Type of fuel Wood & solid fuels
Thickness insulation (mm) 30 mm
Distance to flammables (cm) 6 cm
CE Classification EN 1856-1 T600 N1 D V2 L50040 G60
Temperature of use 600ºC continuous, 1000ºC peak.
Producer Dinak
Delivery time (working days) 1-3
Transport cost (total order) From £8.99, Free delivery over £120.
(Compatible with) internal pipe diameter (mm) 150 mm = 6'

Rate this page

  • Leave a name and email adress if you wish to be contacted