80 mm (pellet)

Pellet stove pipe 80 mm

Pelletrohre

The pellet stove pipe connects the stove tot the flue.

Pellet Stoves need to stand away from a wall by about 8 inches (200mm) to allow for a small condensation trap which must be fitted on the flue immediately it leaves the stove.

The flue for pellet stoves can be installed into an existing masonry chimney usually using an approved chimney liner to keep the old chimney liner from degrading and possibly falling in and blocking the exhaust gases. If you have a standard brick 9 inch sq flue as in most UK houses built in the last century, it is advisable to line it with a single 5 inch single wall flue liner.

Proper flue size (diameter) is very important for safe and efficient operation. They use only a small diameter flue pipe of 80mm. Be sure to seal the joints and seams of the flue with a sealant recommended by the flue manufacturer or supplier.

Pellet stoves are required to stand on a hearth but because the temperature at the base of the stove never gets too high this need only be a half inch (12.5 mm) high rather than the usual 50mm.

There are no products matching the selection.

Rate this page

  • Leave a name and email adress if you wish to be contacted